Mackie has created a Scarecrow Treat Holder using the Let's Be Friends stamp set...this is a perfect addition to any fall gathering!
Supplies Needed:
Misti Stamp Positioner
Directions:
Cut all card stock with the measurements listed:
-craft 3 3/4 X 7 inches ~Score on Long side-1/2, 1 ¾, 3 ¾, and 5 inches ~Score on short side- 2 ¼ and 3 ¼ inches
-Blue Card Stock. 6 X 5 ¼ inches
-Brown Card stock 2 X 1 3/4
-Orange Pattern Paper 2 ¼ X 5/8
Trim the corners off of the blue card stock as shown in the photos. Glue and put together. This will be the bottom box that your treats will fit into.
Score the craft paper....BEFORE you put it together, stamp your eyes, nose and mouth as in the photo. Then put the box together. Staple the top of the milk carton.
Stamp the Hat stamp with the white ink onto brown cardstock. Then fussy cut it out.
I cut another piece of brown cardstock 2 X 1 ¾ inches. Take a white pen and make dash marks all around the edges. This will be the top of the hat!
Take about a ¾ inch strip of yellow card stock and make a fringe with your scissors as shown in the photo. Then cut it into sections. These can be glued under the hat etc, as straw sticking out of the scarecrow..
I attached the hat and the orange gingham check paper pieces to the milk carton, to create my scarecrow! And for a special touch, I added a flower from my stash!
1 comment
Linda K
Oh how cute! The scarecrow box is adorable!!! You did an awesome job! Thanks for sharing!